Reusable, above-ground stringline supports for kerb setting-out. Adjust the line and level. Retrieve the supports. Use them again—with no traditional setting-out pins required.
Stringlines are a familiar part of kerb setting-out. Driving pins into the ground introduces an additional consideration where buried services may be present.
PSL supports the stringline from above ground. A reusable base, upright and adjustable connection work together to position the line where it is needed.
Site demonstration: an engineer retrieves the PSL base after the kerbs have been laid and the kerb backing installed, ready for the components to be used again. Silent viewing copy; development configuration shown. This clip is not an installation guide.
Place above-ground supports along the proposed kerb line, subject to suitable site conditions.
02
Fit the upright
Assemble the upright and adjustable connection in accordance with the confirmed user instructions.
03
Set the stringline
Connect and adjust the stringline to the required alignment and level.
04
Check, work and reuse
Verify the setting-out, monitor the line during work, then remove and relocate the system.
03 / THE ADVANTAGE
Four principles. One practical system.
01
Safe
No driven setting-out pins required.
PSL eliminates the need for traditional driven setting-out pins. Choose a suitable ballasted arrangement to avoid ground penetration; optional nailed installations still penetrate the surface and require appropriate site controls.
02
Accurate
Fine adjustment. Less rework.
Adjust the pigtail bolt for line and level to target millimetre accuracy and help reduce rework. Achievable accuracy depends on survey control, setup, line span and tension; verified performance figures are not yet available.
03
Quick
Set up. Adjust. Move on.
Designed for fast installation, adjustment, removal and relocation as work progresses.
04
Sustainable
Made for repeated use.
Reusable components reduce dependence on disposable or replacement setting-out equipment. Service life depends on use, inspection and care.
PSL does not replace buried-service checks, site risk assessments or approved working methods.
04 / THE STARTER BOX
One box. Your next 100 metres.
10 support assemblies. 100 m of red stringline. Ready to plan your next kerb set-out.
Red plastic bases, polystyrene infill mattresses, slotted tubes, pigtail bolts, top protection caps and chrome bolt end caps—plus a kerb clamp and an instruction brochure.
Intended for 100 m of kerbing. Support quantities and spacing depend on the alignment and site conditions.